Mango heat pump dryer is in the form of continuous hot air
circulation, which can improve the utilization of energy
efficiency. The utilization of energy efficiency has two meanings.
From the perspective of environment, it can reduce the emissions of
greenhouse gases and reduce the harmful factors to the environment.
On the other hand, it is a new technology instead of traditional
Air energy heat pump dryer is a new type of high-efficiency
energy-saving dryer, which uses the principle of inverse Carnot
cycle to drive the compressor with a small amount of electric
energy. The high-pressure liquid working medium evaporates into gas
state in the evaporator after passing through the expansion valve,
and absorbs a large amount of heat energy in the air. The gas
working medium is compressed into high-temperature and
high-pressure liquid by the compressor, Then enter the condenser
for heat release, and send the heat generated by the condenser to
the drying room for heating and drying through the fan.
Application scope of heat pump dryer:
Because the heat pump dryer is not affected by the external
environment, weather, season and climate, it can work continuously
for 24 hours, and can well guarantee the quality, color, appearance
and effective composition of the dried products, It can meet the
drying requirements of different products, so it can be widely used
in the drying of agricultural and sideline products, aquatic
products, meat products, traditional Chinese medicine, fruits and
vegetables, food, grain, seeds, clothing, tea, paper and other
Advantages of air energy heat pump dryer:
1. High efficiency
The equipment adopts the fully sealed structure and inner hot air
circulation, which greatly shortens the material drying time and
ensures the product output. Moreover, it is easy to install and
remove, with less floor area, and can be installed indoors and
2. energy saving
The equipment can absorb a large amount of heat in the air ,it only
needs a small amount of electric energy consumption, which is only
1 / 4 of the electric heater. Compared with coal, oil and gas
dryers, it can save about 70% of the operating cost.
3. environmental protection
No waste heat, waste gas, combustibles and emissions will be
generated during the operation of the equipment, and there is no
risk of flammability, explosion, poisoning, short circuit and other
hazards that may exist in the traditional dryer.
The equipment is equipped with multiple safety protection
functions, such as phase sequence protection, phase loss
protection, overload protection, high and low voltage protection,
etc. the water and electricity are completely separated and there
is no potential safety hazard.
Its closed cyclet structure is very important for food, medicine or
biological products to avoid impurity pollution caused by gas
exchange with the outside world.
The equipment is free of manual operation, no special person is
required to take care of it, the material does not need to be
turned over, the intelligent automatic control drying time and
dehumidification time are stable and easy to operate. According to
the characteristics of the material, the material can be dried at
different temperatures in multiple time periods, and 10 drying
process parameters can be stored.
Service before sell:
----Provide relative technical data for help equipment selection
----Running pilot test
----Offering advice for equipment selection, material analysis
----Provide flow chart, basic drawing
----Provide technical design
Service in sell:
----Provide factory layout according to contract
----Manufacturing ordered equipment according to the related
---- A presentation report of manufacturing situation will be
offered every 15days
---- Tracking and supervising in whole manufacturing and
transporting period according to the contract requirement
---- Photo of wooden case will be offered, wooden case with
standard shipping marks.
---- Photo of freight loading will be offered.
---- A record of detailed delivery list will be offered
---- A record of detailed freight loading list will be offered
---- All of wooden case will be marked serial number, all of
attachments will be marked serial number, convenient for client's
Service after sell:
----Send service engineer for help instruct installation.
----Send service engineer for running test at site and training the
----Help client for maintenance and repair
----Provide one year spare part
----Quality warranty for two years after sell
Packing and delivery